Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Справочник по командам

Страница: 1270 / 1502

local ip address
Syntax From L2TP Destination Profile Host Configuration mode:
local ip address ipAddress
no local ip address
From IPSec Transport Profile Configuration mode:
[ no ] local ip address transportIpAddress
From IPSec Tunnel Profile Configuration mode:
local ip address transportIpAddress { pre-share keyString
| pre-share-masked maskedKeyString }
no local ip address
Release Information Command introduced before JunosE Release 7.1.0.
IPSec Tunnel Profile Configuration mode added in JunosE Release 7.3.0.
Description From L2TP Destination Profile Host Configuration mode, configures a local IP address
for use with a remote host. The
no version removes the local IP address from use with a
remote host.
From IPSec Transport Profile Configuration mode, specifies the local endpoint of the
IPSec transport connection. It also enters Local IPSec Transport Profile Configuration
mode. The
no version deletes the local IP address.
From IPSec Tunnel Profile Configuration mode, specifies the given local IP address as a
server address. The router continues to monitor UDP port 500 for incoming user login
requests (that is, IKE source address negotiations). When using global preshared keys,
consider the following points:
•
Global preshared keys enable a group of users to share a single authentication key.
Using a shared key for a group of users simplifies the administrative job of setting up
keys. However, changing or removing a preshared key for one user (for security reasons)
affects other users with the same key.
•
Specific keys for individual users take precedence over global keys assigned to the
same user. In other words, if a user has both an assigned specific key and a global key
that user must use the specific key or authentication fails.
•
Avoid specifying the same local endpoint and virtual router in the same profile. Local
endpoint and virtual router values override each other. The last value set in the profile
is the value used.
The no version causes the router to stop monitoring UDP port 500 for user requests and
removes any preshared key associations with the local IP address.
Copyright © 2010, Juniper Networks, Inc. 1226
JunosE 11.2.x Command Reference Guide A to M