Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Справочник по командам

Страница: 1259 / 1502

line
Syntax line { console lineNumber | vty lineRangeStart [ lineRangeEnd ] }
no line vty lineNumber
Release Information Command introduced before JunosE Release 7.1.0.
Description Opens virtual terminal lines or the console line and allows you to configure the lines. By
default five vty lines (0–4) are open. The
no version removes a vty line or a range of lines
from your configuration; users will not be able to run Telnet, SSH, or FTP to lines that you
remove. When you remove a vty line, the router removes all lines above that line. For
example,
no line vty 6 causes the router to remove lines 6 through 29. You cannot remove
lines 0 through 4.
NOTE: Once lines are open, login is enabled by default. Before users can access the
lines, you must configure a password, disable login using the no login command, or
configure AAA authentication on the line.
Options
•
console—Specifies the console line
•
vty—Specifies vty lines
•
lineNumber— Number of a single line; 0 for the console line
•
lineRangeStart —Start of the vty line range; a number from 0–29
•
lineRangeEnd —End of the vty line range; a number from 0–29
Mode Global Configuration
1215 Copyright © 2010, Juniper Networks, Inc.
Chapter 12: L Commands