Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Справочник по командам

Страница: 1144 / 1502

ipv6 prefix-list
Syntax ipv6 prefix-list listName { description desc | { [ seq sequence ] { permit | deny } ipv6Prefix
[ ge geNumber ] [ le leNumber ] } }
no ipv6 prefix-list listName [ description | [ seq sequence ] [ { permit | deny } ipv6Prefix
[ ge geNumber ] [ le leNumber ] ] ]
Release Information Command introduced before JunosE Release 7.1.0.
Description Creates an IPv6 prefix list for route filtering; specifies a list entry—a permit or deny clause
for a network address. The
no version removes the specified prefix list or the specified
list entry.
Options
•
listName —Name of the IPv6 prefix list; a string of up to 32 characters
•
desc —Description of the prefix list
•
sequence—Number in the range 0–65535 that indicates the position the prefix list
entry has in the already existing list of entries for the prefix list; if you do not specify a
sequence , the command uses the value of the last sequence 5
•
permit—When specified, the router redistributes any prefix that matches the filtered
route based on the set actions
•
deny—When specified, the router drops any prefix that matches the filtered route
•
ipv6Prefix —Network route that you want to filter, in the format ipv6Address / length ,
where
•
ipv6Address— Base IPv6 address of the network route that you want to filter (for
example, ::ffff:a:b:c:d)
•
length —Length of the network prefix; number of bits masking base address to produce
address to be matched
•
geNumber —Route being filtered matches if its prefix is within the range specified:
greater than or equal to geNumber and less than or equal to 32
•
leNumber —Route being filtered matches if its prefix is within the range specified: greater
than or equal to length and less than or equal to leNumber
Mode Global Configuration
Copyright © 2010, Juniper Networks, Inc. 1100
JunosE 11.2.x Command Reference Guide A to M