Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Справочник по командам

Страница: 1011 / 1502

ip vrrp accept-data
Syntax [ no ] ip vrrp vrid accept-data
Release Information Command introduced before JunosE Release 7.1.0.
Description Enables the backup router to process packets with an IP destination address equivalent
to the virtual addresses while the backup router is in the master state. The router ignores
this attribute when the VRRP entry uses a priority of 255. You must use the default state
(disabled) to comply with RFC 3768. When disabled, the master router drops any packets
with an IP destination address equivalent to the virtual address. The
no version restores
the default value, disabled.
NOTE: When using this attribute and also restricting incoming packets to ICMP only,
you must use policy filters to accept only ICMP packets with the virtual address as the
destination address.
Options
•
vrid —VRID identifier; a number in the range 1–255
Mode Interface Configuration
967 Copyright © 2010, Juniper Networks, Inc.
Chapter 10: I Commands