Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Справочник по командам

Страница: 129 / 1502

address area
Syntax [ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
area { areaId | areaIdInt }
Release Information Command introduced before JunosE Release 7.1.0.
Description Creates an interface on which OSPF runs in the specified area, on top of the IP interface
at the specified IP address. Uses the default values. The
no version deletes OSPF
interfaces. If the OSPF network was previously specified with the network area command,
the OSPF interface already exists, and you do not need to use this command, unless you
want to change the area of the OSPF interface to an area different from the one specified
by the
network area command.
NOTE: Before you issue this command, you must first configure an interface with the
IP address specified by ipAddress or an interface configured as unnumbered.
You must issue this command before issuing any other OSPF address command.
Options
•
ipAddress —IP address of the interface on which OSPF will be run
•
unnumbered—Configures OSPF on an unnumbered interface
•
interfaceType —Interface type; see “Interface Types and Specifiers” on page 5
•
interfaceSpecifier— Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
•
areaId—OSPF area ID in IP address format
•
areaIdInt —OSPF area ID as a decimal value in the range 1–4294967295
Mode Router Configuration
85 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: A Commands