Indulogix ILVFE-1W0075, Руководство пользователя

Страница: 39 / 81

ILVFE-series
user manual
39
P106 [Start source]
Related Parameter(s): d012, P107
Sets the control scheme used to start the drive.
Refer to Start and Speed Reference Control on chapter 1 for details about how other drive settings
can override the setting of this parameter.
Important: For all settings except option 3, the drive must receive a leading edge from the start input
for the drive to start after a stop input, loss of power or fault condition.
Options 0
"Keypad" (Default)
•
Integral keypad controls drive operation.
•
I/O Terminal 1 “Stop” = coast to stop.
•
When active, the Reverse key is also active unless
disabled by A434 [Reverse Disable].
1 "3-wire"
•
I/O Terminal 1 “Stop” = stop according to the value set in
P107 [Stop Mode].
2
"2-wire"
•
I/O Terminal 1 “Stop” = coast to stop.
3
"2-wire Lvl sens”
•
Drive will restart after a “Stop” command when: Stop is
removed and Start is held active
4 "2-wire Hi-speed"
•
Outputs are kept in a ready-to-run state. The drive will
respond to a “Start” command within 10 ms.
•
I/O Terminal 1 “Stop” = coast to stop.
Important: There is greater potential voltage on the output
terminals when using this option.
5 "Comm port"
(1)
•
Remote communications. Refer to Appendix C for details.
•
I/O Terminal 1 “Stop” = coast to stop.
(1)
When using option 5 “Comm Port”, if the drive is using a network for control and the user’s program
is maintaining a “Start” or “Jog” command without sending a “Stop command”, the drive will start
automatically when power is cycled.
Attention: Hazard of injury exists due to unintended operation.
When P106 [Start Source] is set to option 3 , and the Run input is maintained, the
Run inputs do not need to be toggled after a Stop input for the drive to run again.
A Stop function is provided only when the Stop input is active (open).
Stop drive before changing this parameter