Indulogix ILVFE-1W0075, Руководство пользователя

Страница: 19 / 81

ILVFE-series
user manual
19
Figure 1.5 Control wiring Block diagram
No Signal Default Description Parameter
R1
Relay N.O. Fault Normally open contact for output relay.
t221
R2
Relay Common - Common for output relay.
R3 Relay N.C. Fault Normally closed contact for output relay. t221
Sink/Source DIP switch
Source
(SRC)
Inputs can be wired as Sink (SNK) or Source (SRC) via DIP
Switch setting.
01 Stop
(1)
Coast
The factory installed jumper or a normally
closed input must be present for the drive to
start.
P106
02 Start/Run FWD
(2)
Not active Command comes from the integral keypad by
default. To disable reverse operation, see A095
[Reverse Disable]. P106, P107
03 Direction/Run REV Not active
P106, P107,
A434
04
Digital common
-
For digital inputs. Electronically isolated with
digital inputs from analog I/O.
05
Digital input 1 Preset freq Program with t201 [Digital In1 Sel].
t201
06
Digital input 2 Preset freq Program with t202 [Digital In2 Sel].
t202
11 +24V DC -
Drive supplied power for digital inputs.
Maximum output current is 100mA
12 +10V DC +10V DC
Drive supplied power for 0-10V external
potentiometer.
Maximum output current is 15mA.
P108
13 0-10V in * Not active
For external 0-10V input supply (input
impedance = 100k
Ω) or potentiometer wiper.
P108
14 Analog common -
For 0-10V In or 4-20mA In. Electronically
isolated with analog inputs from digital I/O.
15 4-20mA in * Not active
For external 4-20mA input supply (input
impedance = 250
Ω).
P108
16 RS485 shield -
Terminal should be connected to Safety ground
- PE when using the RS485 communications
port.
* Only one analog frequency source may be connected at a time. If more than one reference is connected at the same time, an
undetermined frequency reference will result.