Indulogix ILVFE-1W0075, Руководство пользователя

Страница: 66 / 81

66
ILVFE-series
user manual
No. Fault Type Description Action
F33 Auto rstrt tries
②
Drive unsuccessfully
attempted to reset a
fault and resume
running for the
programmed number
of A451 [Auto Rstrt
Tries].
Correct the cause of the fault and
manually clear.
F35 Phase U to gnd
②
A phase to ground
fault has been
detected between
the drive and motor
in this phase. 1. Check the wiring between the drive
and motor.
2. Check motor for grounded phase.
3. Replace drive if fault cannot be
cleared.
F39 Phase V to gnd
F40 Phase W to gnd
F41 Phase UV short
②
Excessive current
has been detected
between these two
output terminals. 1. Check the motor and drive output
terminal wiring for a shorted condition.
2. Replace drive if fault cannot be
cleared.
F42 Phase UW short
F43 Phase VW short
F48 Params defaulted
The drive was
commanded to write
default values to
EEPROM. 1. Clear the fault or cycle power to the
drive.
2. Program the drive parameters as
needed.
F63 SW overcurrent
①
Programmed A448
[SW current trip] has
been exceeded.
Check load requirements and A448 [SW
current trip] setting.
F64 Drive overload
②
Drive rating of 150%
for 1 minute or 200%
for 3 seconds has
been exceeded.
Reduce load or extended accel time.
F70 Power unit
②
Failure has been
detected in the drive
power section. 1. Cycle power
2. Replace drive if fault cannot be
cleared.
F71 Net loss
The communication
network has faulted.
1. Cycle power.
2. Check Communications cabling.
3. Check network adapter setting.
4. Check external network status.
F81 Comm loss
②
RS485(DSI) port
stopped
communicating.
1. If adapter was not intentionally
disconnected, check wiring to the port.
Replace wiring, port expander,
adapters or complete drive as required.
2. Check connection.
3. Turn off using C304 [Comm loss
action].
F100
Parameter
checksum
②
The checksum read
from the board does
not match the
checksum
calculated.
Set P112 [Reset to defaults] to option 1
“Reset defaults”.
F122 I/O board fail
②
Failure has been
detected in the drive
control and I/O
section.
1. Cycle power
2. Replace drive if fault cannot be
cleared.