Indulogix ILVFE-1W0075, Руководство пользователя

Страница: 64 / 81

64
ILVFE-series
user manual
Manually clearing faults
Step Action Keys
1
Press Esc to acknowledge the fault. The fault information will be removed so that
you can use the integral keypad.
Access d007 Fault 1 Code to view the most recent fault information.
2
Address the condition that caused the fault.
The cause must be corrected before the fault can be cleared.
See Table 4.A.
3
After corrective action has been taken, clear the fault by one of these methods:
•
Press Stop if P107 [Stop Mode] is set to a value between “0” and “3”.
•
Cycle drive power.
•
Set A450 [Fault Clear] to “1” or “2”.
•
Cycle digital input if t201 - t202 [Digital Inx Select] is set to option 7 “Clear
Fault”.
Automatically clearing faults
Clear a type 1 fault and restart the drive:
Step Action
1 Set A451 [Auto rstrt tries] to a value other than “0”.
2 Set A452 [Auto rstrt delay] to a value other than “0”.
Clear an overvoltage, undervoltage or heatsink ovrtmp fault without restarting the drive.
Step Action
1 Set A451 [Auto rstrt tries] to a value other than “0”.
2 Set A452 [Auto rstrt delay] to “0”.
Auto restart (Reset/Run)
The Auto Restart feature provides the ability for the drive to automatically perform a fault reset
followed by a start attempt without user or application intervention. This allows remote or “unattended”
operation. Only certain faults are allowed to be reset. Certain faults (Type 2) that indicate possible
drive component malfunction are not resettable.
Caution should be used when enabling this feature, since the drive will attempt to issue its own start
command based on user selected programming.