48
IDS X-Series Training v2.7
Location 231: Primary Entry Delay
Location Type: Extended
There is a sub-location for each of the 8 partitions.
This is the time a person has from triggering the primary entry/exit zone to entering a valid disarm code
before triggering the alarm. When the entry/exit zone triggers, it automatically disables the follower zones.
There is a secondary entry delay (location 232) for a different entry times.
Format: mmss
Default: 0030
Valid range: 0000 to 5959
Exercise:
Location 232: Secondary Entry Delay
Location Type: Extended
There is a sub-location for each of the 8 partitions.
This is the time a person has from triggering the secondary entry/exit zone to entering a valid disarm code
before triggering the alarm. When the entry/exit zone triggers, it automatically disables the follower zones.
Format: mmss
Default: 0030
Valid range: 0000 to 5959
Keypad Configuration
Each X-Series system can have up to eight LCD or LED keypads controlling it. Keypads can be allocated to
any partition.
To register a keypad:
When a new keypad or after a factory or keypad default, all the keypads LEDs will flash. By pressing
the [#] key the keypad will ask the system for an ID. The first available ID will be given to the keypad.
To clear a keypads ID hold down the 1 and 3 keys while powering the keypad up.
NOTE: By default all keypads, when registered, belong to partition 1.
If a keypad is allocated to a partition without any zones enabled it will display "Not ready."
Location 240: Keypad and Partitions
Location Type: Extended
There is a sub-location for each of the 8 keypads.
Each keypad when registered will belong to partition 1.
Valid range: 1 – 8
Default: 1
Exercise: Add keypad 1 to partition 1, keypad 2 to partition 2, 3 to partition 3 and 4 to 4.
Instructions
Keypad presses
Enter the location 231
[2][3][1] [*]
Enter partition 1’s sub-location
[1] [*]
Change the 30 sec default to 10sec (mmss)
[0][0] [1][0] [*]
Exit the location
[#]
Instructions
Key presses
Enter location 240
[2][4][0] [*]
Now enter the string for each of the keypads and the keypads not installed
leave as default by leaving them in partition 1
[1] [2] [3] [4] [1] [1] [1] [1] [*]
When the [*] key is entered the data will be saved and you will be exited out
of the location