112
IDS X-Series Training v2.7
2.2.
Adding Phone Numbers
In the default state any cell phone can be used to enter the first “Master Phone Number”, you can only add
another phone number to the X-SMS Module using a “Master Phone Number”.
There are different types of categories a phone number can fall under:
Master Phone Number
Master phone numbers have the highest level of access to the SMS Module, they are allowed access to all
configuration data.
Arming phone Numbers
Arming phone numbers have permissions for all panel functions, arm/disarm, panel status, bypass zone,
PGM control and receive reports.
Reporting Phone Numbers
Reporting phone numbers are only permitted to receive reports from the SMS module, and to temporarily
turn off reporting to that number.
To add a Master Phone Number you will use the following information:
Code – 1234 (a user code)
Command – Add
Extended Command – Master (category the number must be under)
Data – 074 049 2481 (the number to be made master)
The SMS should look like this:
1234 add master 0740492481
All phone number commands:
Action
Code
Command
Ext. Command
Data
Add phone number as an
Master number
1234
Add
Master
074 049 2481
Add phone number as an Arm
number
1234
Add
Arming
073 917 0759
Add phone number as a
Reporting number
1234
Add
Reporting
071 348 9467
Deleting a phone number
1234
Delete
074 049 2481
2.3.
Reporting
Each phone number can turn reporting off, as well as choose how they want to receive reporting
messages.
On/Off – Enables/Disables reporting to the phone that sent the SMS.
Global – Events that are not partition related. Eg. Ac Fail.
P1;P2;P3... – Events that are partition based. (P1 for partition 1, P2 for partition 2 and so on) Eg.
Arm/Disarm.
Type – Enables the type of reporting that the phone number will receive.
There are three types to choose from:
Raw – A contact ID string is sent to the phone.
Full – All enabled events will be sent to the phone in English.
Reduced - Only the following will be reported: Arm/Disarm, Zone violations, Panics, AC
Fail/Restore and Battery Low/Restore. (This is the default)
