120
IDS X-Series Training v2.7
2.
Event Reporting
When an event needs to be reported, the panel will dial the user and the login sequence will begin.
The user will hear a series of beeps followed by three seconds of silence. This sequence will continue for
forty seconds. This will be interrupted by the first DTMF tone detected, key press, during the silence.
During the three seconds of silence a valid user code should be entered and the module will first
acknowledge the correct code with “welcome” and then begin delivering the events.
If an incorrect code is entered the voice module will indicate this with “code incorrect”. Three incorrect
code entries will cause the system to hang up.
The events delivered will depend on the user code and which partitions that code belongs too. Global
events will be delivered to all users, i.e. ac fail. Once all events have been delivered the system will wait for
further instructions.
3.
User Initiated Communication
After picking up the phone line, the panel will first try and communicate with a modem by giving the
modem handshake tones, and if this fails it will then start the login sequence.
The login sequence is a series of beeps followed by three seconds of silence for a valid user code to be
entered, this will continue for forty seconds if a code is not entered. After the forty seconds or three
incorrect attempts at guessing the code, the system will drop the line.
When the user inserts the correct code the voice module will respond with, “Welcome, press star for menu
or enter number” and is given access to the menu.
4.
User Menu
Key Press
Action
Reply
[*]
Menu details
“Press 1 for status, press 2 to arm disarm “
[1]
Full status report (arm status, alarmed zones,
siren status, bypass status)
Partition 1 armed / dis-armed....
[2]
Arm / disarm
Enter partition
[3]
Switch siren off
Siren off
[4]
Programmable outputs
Enter output
[5]
Bypass / Unbypass
Enter zone
[6]
Alarm memory
Zone.....
4.1.
Menu Details
To hear which keys to press for the required action:
Press [*]
Voice
“1 status report, 2 arm/disarm ...”
4.2.
Status report
To get a status report on the partition and its zones:
Press [1]
Voice
“partition 1 disarmed, zone 3 bypassed...”
4.3.
Arm / Disarm
To arm or disarm a partition:
Press [2]
Voice
“enter partition”
Press [partition number]
Voice
“partition number armed”