IBM 8645 - Eserver xSeries 220, Руководство по техническому обслуживанию аппаратной части

Страница: 76 / 168

Installing a non-hot-swap hard disk drive in bay 5, 6, or 7
Locking tab
To install a non-hot-swap hard disk drive in bay 5, 6, or 7, do the following:
1. Read the information in “Preinstallation steps (all bays)” on page 66.
2. Turn off the server and peripheral devices, and disconnect all external cables
and power cords; then, remove the cover (see “Removing the side cover” on
page 57 for details).
3. Remove the support bracket assembly (see “Removing the support bracket
assembly” on page 59).
4.
Rotate the drive cage upward. If the server has a hard disk drive installed in
the drive cage, disconnect the cables from the rear of the drive.
5. Remove the plastic bag that contains the drive rails and screws from inside the
drive cage.
6.
Install rails on each drive in the drive cage:
a. Pull the blue slide rails out of the plastic bag.
b. Install the screws on the sides of the drive.
c. Align the rails on the drive with the guide rails in the drive bay.
d. Push the drive into the bay until it clicks into place.
7. Reinstall the drive cage in the server. Rotate the drive cage downward until it
snaps into place.
8. Connect the server SCSI and power cables to the rear of the drives.
Note: Ensure that you route the SCSI cable so that it does not block the airflow
to the rear of the drives or over the microprocessors.
9.
If you have other options to install or remove, do so now; otherwise, replace
the support bracket assembly; then go to “Installing the cover” on page 79.
68
Hardware Maintenance Manual: xSeries 220 Type 8645