IBM 8645 - Eserver xSeries 220, Руководство по техническому обслуживанию аппаратной части

Страница: 33 / 168

Table 5. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet
controller (continued)
Error code
(hex) Description
0x02 Explanation: Bad node address (multicast address). Action: Make sure the
locally administered address is valid, if one is specified. The address can
not be a multicast address.
0x03 Explanation: Failed self-test. Action: Make sure a cable is attached to the
Ethernet connector. If the problem persists, call for service.
0x0D Explanation: Could not allocate enough memory for transmit queues.
Action:
1.
From the Windows NT desktop, select Start -> Control Panel ->
Networks -> Adapters .
2. Select your IBM Ethernet adapter from the list.
3. Select Properties -> Advanced .
4. Lower the resource values that apply to the transmit queue.
0x0E Explanation: Could not allocate enough memory for receive queue. Action:
1. From the Windows NT desktop, selec t Start -> Control Panel ->
Networks -> Adapter s.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties -> Advanced .
4. Lower the resource values that apply to the receive queue.
0x0F Explanation: Could not allocate enough memory for other structures.
Action:
1. From the Windows NT desktop, select Start -> Control Panel ->
Networks -> Adapters .
2. Select your IBM Ethernet adapter from the list.
3. Select Properties -> Advanced .
4. Lower the value for the resource named in the message.
0x10 Explanation: Did not find any Ethernet controllers. Action: Using the
Configuration/Setup Utility, make sure that Ethernet is enabled.
0x11 Explanation: Multiple Ethernet controllers found, but none matched the
required ID.
Action:
Using the Configuration/Setup Utility, make sure that
Ethernet is enabled.
0x13 Explanation: Did not find any Ethernet controllers that matched the
required subven/subdev. Action: Using the Configuration/Setup Utility,
make sure that Ethernet is enabled.
0x16 Explanation: Single adapter found but multiple instances tried to load.
Action: Using the Configuration/Setup Utility, make sure that Ethernet is
enabled, and that the slot containing the IBM 10/100 Ethernet Adapter or
the IBM 10/100 EtherJet
™
PCI adapter is enabled.
0x17 Explanation: Slot parameter not specified in the registry. Action: Remove
the adapter driver and reinstall it. If the problem persists, call for service.
All other
4-character
hexadecimal
codes
Action:
Call for service.
Diagnostics
25