IBM 8645 - Eserver xSeries 220, Руководство по техническому обслуживанию аппаратной части

Страница: 107 / 168

To remove the rear fan, do the following:
1.
Power-off the server, if it is on.
2. Unplug the server.
3. Remove the cover (see “Removing the side cover” on page 57).
4. Remove the support bracket (see “Removing the support bracket assembly” on
page 59 ).
5. Remove the fan cable from the system board.
6. Use side cutters to sever the four rubber extensions on the outside of the
server.
7. Gently pry the fan away from the server and lift it up and out.
8.
To install the new fan assembly, place the fan in position at the rear of the
server.
9. Guide the rubber extensions through the apertures.
10.
Use needle-nosed pliers to pull the extensions through the apertures.
11. Reconnect cables.
System board
Before you begin:
v
Read “Safety information” on page 123.
v
Review the information in “System reliability considerations” on page 56.
Note: It is recommended that the server be placed on its left side before
performing this service procedure. Rotate the feet in toward the server so
they do not detach due to the weight of the server.
To remove the system board, do the following:
1. Power-off the server, if it is on.
2.
Unplug the server.
3. Remove the cover (see “Removing the side cover” on page 57).
4.
Remove the front bezel (see “Removing the bezel” on page 58).
5. Remove the support bracket (see “Removing the support bracket assembly” on
page 59).
6. Disconnect the cables.
FRU information (service only)
99