IBM 8645 - Eserver xSeries 220, Руководство по техническому обслуживанию аппаратной части

Страница: 66 / 168

1. Review the information in “System reliability considerations” on page 56.
2.
Turn off the server and all attached devices and disconnect all external cables
and power cords.
3. If necessary, unlock the server cover.
4. Pull out on the cover-release latch near the rear of the server cover; then, slide
the cover toward the rear of the server and remove it.
Attention: For proper cooling and airflow, replace the cover before turning
on the server. Operating the server for extended periods of time (over 30
minutes) with the cover removed might damage server components.
5. For a tower model, rotate the stabilizing feet on the bottom of the server, and
place the server on its side to install or remove components.
Removing the bezel
The following illustration shows how to remove the bezel from the server.
Note: The illustrations in this document might differ slightly from your hardware.
Do the following to remove the bezel:
1. Review the information in “System reliability considerations” on page 56.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords.
3. Remove the side cover (see “Removing the side cover” on page 57).
4. Press the bezel-release latch at the top of the server to disconnect the top of the
bezel from the server.
5. Release the two tabs at the top edge of the bezel and pull the top of the bezel
slightly away from the server.
6.
Pull the bezel up to release the two tabs at the bottom edge of the bezel. Store
the bezel in a safe place.
58
Hardware Maintenance Manual: xSeries 220 Type 8645