IBM 8645 - Eserver xSeries 220, Руководство по техническому обслуживанию аппаратной части

Страница: 108 / 168

7. Remove the adapter cards and both adapter retaining brackets (see “Installing
an adapter” on page 62).
8.
Remove the hot-swap hard disk drive cage (see “Hot-swap hard disk drive
cage” on page 96).
9. Remove memory modules (see “Installing memory modules” on page 72).
10. Remove microprocessors and/or terminator cards (see “Installing and
removing a microprocessor” on page 73).
11. Remove screws and lift the system board out of the server.
CD-ROM drive
Before you begin:
v
Read “Safety information” on page 123.
v
Review the information in “System reliability considerations” on page 56.
To remove the CD-ROM drive, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the cover (see “Removing the side cover” on page 57).
4. Disconnect the cables.
5. Remove the screws from the CD-ROM drive cage.
6.
Gently slide the floppy disk drive toward the rear of the server and lift it out.
Floppy disk drive
Before you begin:
v
Read “Safety information” on page 123.
v
Review the information in “System reliability considerations” on page 56.
100
Hardware Maintenance Manual: xSeries 220 Type 8645