IBM 8645 - Eserver xSeries 220, Руководство по техническому обслуживанию аппаратной части

Страница: 103 / 168

FRU information (service only)
Button kit . . . . . . . . . . . . . . . 95
Hot-swap hard disk drive cage . . . . . . . . 96
Hot-swap backplane . . . . . . . . . . . 96
Power supply . . . . . . . . . . . . . 97
Rear fan . . . . . . . . . . . . . . . 98
System board . . . . . . . . . . . . . . 99
CD-ROM drive . . . . . . . . . . . . . 100
Floppy disk drive . . . . . . . . . . . . 100
Bezel release latch . . . . . . . . . . . . 101
Top/side cover . . . . . . . . . . . . . 102
Handle assembly . . . . . . . . . . . . 103
Adapter retainer . . . . . . . . . . . . 103
Field Replacement Units (FRUs) should be replaced by qualified service personnel
only.
Button kit
Before you begin:
v
Read “Safety information” on page 123.
v
Review the information in “System reliability considerations” on page 56.
To remove the button kit, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the cover (see “Removing the side cover” on page 57).
4. Remove the front bezel (see “Removing the bezel” on page 58).
5.
Remove the hot-swap hard disk drive (see “Hot-swap hard disk drive cage” on
page 96).
6. Disconnect the cable of the button kit from the system board.
7.
Place a screwdriver against the bottom release latch of the button kit and gently
press upward and slide the latch through the aperture.
© Copyright IBM Corp. 2000
95