IBM 315, Дополнение к руководству по техническому обслуживанию оборудования, Страница: 66 / 151

Removing an Unknown
Power-On/Administrator Password
The following procedure outlines how to remove an
unknown (or forgotten) power-on password.
Attention
This procedure erases the current server
configuration. Be sure to record the server
configuration before performing this procedure. You
must reconfigure the server after you move the
password jumper. The &admp. and power-on
password share the same jumper, known as the
password jumper.
1. Power-off the server.
2. Locate the password jumper (PWD) in the
system-board illustration in “System Board” on
page 96. The jumper settings are shown in the
following illustration.
Normal
Erase
3 2 1
3 2 1
3. Change the jumper's position:
a. Lift the jumper straight off the pin block.
b. Align the holes in the bottom of the jumper with
the center pin and the pin that was not covered
previously.
c. Slide the jumper over these pins.
This procedure removes the password.
62
PC Server HMM