IBM 315, Дополнение к руководству по техническому обслуживанию оборудования, Страница: 48 / 151

NDIS 3.0 Driver Messages:
Windows NT error
messages are logged into a log file. You can view the file
with the Event Viewer. Error messages appear with the
“PCNTN3” prefix followed by a “Missing Configuration
Parameter” message and several hex numbers. The hex
numbers must be converted to decimal values so that they
correspond to the error numbers used in this manual.
PCNTN3-9 IO base address is already in use by
another PCNET device.
Explanation: The specified IO address number is already
in use by another device.
Action: Modify the IO address setting on the hardware or
modify the IO Address setting in the setup dialog box.
PCNTN3-13 IRQ and/or DMA number is already in use
by another device.
Explanation: The specified IRQ is specified by another
device.
Action: Modify the IRQ setting in the setup dialog box.
PCNTN3-18 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet
controller on the PCI bus.
Action: Do the following:
1. Verify that the Ethernet enable jumper is set to the
default Enable position.
2. If the problem persists, go to “General Checkout” on
page 2.
PCNTN3-19 LanceOpenAdapter failed.
Explanation: The configuration is set up incorrectly.
Action: Rerun the setup program.
PCNTN3-20 Device at specified IO base address not
found.
Explanation: The Ethernet controller cannot be found at
the specified IO address.
Action: Verify that the IO address matches with the
board. Otherwise, remove the IO Address specification
from the setup.
PCNTN3-21 Device not found.
Explanation: The driver cannot find any PCnet device.
Action: Do the following:
1. Verify that the Ethernet enable jumper is set to the
default Enable position.
2. Go to “General Checkout” on page 2.
44
PC Server HMM