IBM 315, Дополнение к руководству по техническому обслуживанию оборудования, Страница: 46 / 151

PCNTND-DOS-16 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet
controller on the PCI bus.
Action: Do the following:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. If the problem persists, go to “General Checkout” on
page 2.
3. Replace the system board.
PCNTND-DOS-21 Board failed checksum test. Please
run configuration utility.
Explanation: The driver cannot find an Ethernet
controller.
Action: Do the following:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. If the problem persists, go to “General Checkout” on
page 2.
PCNTND-DOS-23 WARNING: PCNET IRQ found
=
Explanation: The IRQ setting in PROTOCOL.INI does
not match the hardware IRQ setting.
Action: Remove the IRQ setting from PROTOCOL.INI (or
match the IRQ setting in PROTOCOL.INI with the
configuration settings in the configuration programs. See
“Resolving Hardware Configuration Conflicts” on page 77
for information on setting the interrupt requests.)
PCNTNW-DOS-24 WARNING: PCNET IRQ doesn't
match protocol.ini.
Explanation: The IRQ setting in PROTOCOL.INI does
not match the hardware IRQ setting.
Action: Remove the IRQ setting from PROTOCOL.INI or
match the IRQ setting in PROTOCOL.INI with the
hardware jumper setting.
PCNTNW-DOS-25 PCI scan specified, PCI bus not
found!
Explanation: The driver cannot locate the Ethernet
controller on the PCI bus.
Action: Do the following:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. Go to “General Checkout” on page 2.
42
PC Server HMM