IBM 315, Дополнение к руководству по техническому обслуживанию оборудования, Страница: 50 / 151

PCNTPK-DOS-6
<
IRQ=int_no
>
should be between 0
and 15 inclusive.
Explanation: The specified IRQ is out of range for the
Ethernet controller.
Action: Use valid IRQ values.
PCNTPK-DOS-7 Packet driver failed to initialize the
board.
Explanation: The board initialization failed.
Action: Do the following:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. Go to “General Checkout” on page 2.
PCNTPK-DOS-8
<
INT
=
packet_int_no
>
should be in the
range 0x60 to 0x80.
Explanation: The specified software interrupt number is
out of the allowable range.
Action: Specify a valid value for the INT parameter.
PCNTPK-DOS-12 PCI device IRQ number mismatch.
Explanation: The specified IRQ number does not match
with the IRQ number assigned by the PCI BIOS.
Action: Remove the IRQ setting.
PCNTPK-15 The device was not found.
Explanation: The driver cannot find an Ethernet
controller.
Action: Do the following:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. If the problem persists, go to “General Checkout” on
page 2.
PCNTPK-DOS-18 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet
controller on the PCI bus.
Action: Do the following:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. If the problem persists, go to “General Checkout” on
page 2.
Packet driver is at segment xxxx.
Explanation: The memory address where the packet
driver is loaded is xxxx.
Action: None.
46
PC Server HMM