Hardware options installation 62
•
DIMMs installed on channel 1 and channel 2 of an installed processor must be identical.
•
In multi-processor configurations, each processor must have a valid Mirrored Memory configuration.
•
In multi-processor configurations, each processor may have a different valid Mirrored Memory
configuration.
Installing a DIMM
1.
Power down the server (on page
17
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
17
).
o
Remove the server from the rack (on page
20
).
4.
Remove the access panel (on page
21
).
5.
Remove the expansion board.
6.
Open the DIMM slot latches.
7.
Install the DIMM.
8.
If removed, install the expansion board. ("
Expansion board options
" on page
72
)
9.
Install the access panel (on page
22
).
10.
Do one of the following:
o
Slide the server into the rack.
o
Install the server into the rack ("
Installing the server into the rack
" on page
30
).
11.
Power up the server (on page
17
).
To configure the memory mode, use HP UEFI System Utilities (on page
106
).
Содержание ProLiant DL160 Gen9
