HP ProLiant DL160 Gen9, Руководство пользователя, Страница: 31 / 139

Setup 31
WARNING: This server is very heavy. To reduce the risk of personal injury or damage to the
equipment:
•
Observe local occupational health and safety requirements and guidelines for manual
material handling.
•
Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. HP recommends that a minimum of two people are required
for all rack server installations. A third person may be required to help align the server if the
server is installed higher than chest level.
•
Use caution when installing the server in or removing the server from the rack; it is unstable
when not fastened to the rails.
CAUTION: Always plan the rack installation so that the heaviest item is on the bottom of the rack.
Install the heaviest item first, and continue to populate the rack from the bottom to the top.
To install the server in an HP, Compaq-branded, Telco, or a third-party rack:
1.
Install the server and cable management arm option into the rack. See the documentation that ships with
the Easy Install Rail Kit.
2.
Connect peripheral devices to the server. For information on identifying connectors, see "Rear panel
components (on page
10 )."
WARNING: To reduce the risk of electric shock, fire, or damage to the equipment, do not plug
telephone or telecommunications connectors into RJ-45 connectors.
For a server using a non-hot-plug power supply:
3.
To prevent the accidental disconnection of the power cord when sliding the server into and from the
rack, secure the power cord through the strain relief clip:
a.
If the clip is positioned too near the power cord that it blocks the power cord plug connection, slide
the clip backward.
b.
Connect the power cord to the server.
c.
Press the top part of the clip, and then pull the clip open.