Honda CB HORNET 160R 2015, Руководство по ремонту

Страница: 223 / 336

12-27
FRONT WHEEL/SUSPENSION/STEERING
Install the fork and temporarily tighten the top bridge bolts.
Tighten the steering stem nut to the specified torque.
TORQUE: 74 N.m (7.5 kgf.m, 55 Ibf.ft)
Turn the steering stem left and right several times and
recheck that there is no vertical play and that the steering
stem rotates smoothly.
Install the following:
– Fork (page 12-21)
– Front wheel (page 12-13)
– Handlebar (page 12-6)
– Cover headlight RR (page 2-2)
– Front cowl (page 2-2)
Loosen the
bottom pinch
bolts when
tighten the stem
nut.
STEERING
STEM NUT
STEERING BEARING PRELOAD
Jack up the motorcycle to raise the front wheel off the
ground.
Position the steering stem to the straight ahead position.
Hook a spring scale to the fork tube and measure the
steering head bearing preload.
Pull the spring scale keeping the scale at a right angle to
the steering stem.
Read the scale at the point where the steering stem just
starts to move.
STEERING BEARING PRELOAD:
STANDARD: 0.7 – 1.3 kgf (1.64 – 2.81 lbf)
If the readings do not fall within the limits, readjust the
steering top thread.
Make sure that
there is no cable
or wire harness
interference.