Honda CB HORNET 160R 2015, Руководство по ремонту

Страница: 248 / 336

14-4
BRAKE SYSTEM
BRAKE FLUID FILLING/AIR BLEEDING
FRONT BRAKE (DISC):
If a brake bleeder/automatic refill system is available
then use the following steps:
Connect the automatic refill system to the reservoir, follow
the manufacturer’s operation instruction.
Connect the commercially available brake bleeder to the
front caliper bleed valve.
Perform the bleeding procedure until the system is
completely flushed/ bleed.
After bleeding the air completely, tighten the brake caliper
bleed valve to the specified torque.
TORQUE: 5.4 N.m (0.6 kgf.m, 4.0 lbf.ft)
FRONT MASTER CYLINDER
Do not mix
different types of
fluid. These are
not compatible
BLEED HOSE
BLEED VALVE
REAR BRAKE LINE:
Connect a bleed hose to the rear brake caliper bleed valve.
Loosen the bleed valve and pump the rear brake pedal
until no more fluid flows out of the bleed valve.
Tighten the bleed valve.
Connect the bleed hose to the CBS bleed valve of the
front brake caliper.
Loosen the bleed valve and pump the rear brake padel
until no more fluid flows out of the bleed valve.
Tighten the bleed valve.
COMBI BRAKE SYSTEM:
Combine brake system (page 14-3) consist of two individual
hydraulic circuit, the front brake line and CBS line.
• Front brake line - Draining procedure same as front
brake non CBS
• CBS brake line & Rear brake line - Follow the below
process:
CBS BRAKE LINE:
Remove the right side cover (page 2-3).
Remove the mounting bolt of brake fluid reservoir. Remove
reservoir cover screw, reservoir cover, set-plate and
diaphragm.
SCREWS
RESERVOIR COVER
SET PLATE/
DIAPHRAGM
Do not allow
foreign material
to enter the
system when
filling the
reservoir.
When using a
commercially
available
brake bleeder,
follow the
manufacture’s
operating
instructions.
BLEED HOSE
CBS BLEED VALVE