Honda CB HORNET 160R 2015, Руководство по ремонту

Страница: 321 / 336

18-1
18. ELECTRIC STARTER SYSTEM
18
ELECTRIC STARTER COMPONENT 18-0
ELECTRIC STARTER DIAGRAM 18-0
SERVICE INFORMATION 18-1
TROUBLE SHOOTING 18-1
STARTER RELAY SWITCH 18-3
NEUTRAL DIODE 18-4
CLUTCH SWITCH 18-5
RIGHT HANDLEBAR SWITCH 18-5
SERVICE INFORMATION
GENERAL
If the current is kept flowing through the starter motor to turn it while the engine is not cranking over, the starter motor may be
damaged.
•
Always turn the ignition switch OFF before servicing the starter motor. The motor could suddenly start, causing serious injury.
•
The starter motor can be serviced with the engine in the frame.
•
When checking the starter system, always follow the steps in the troubleshooting (page 18-1).
•
A weak battery may be unable to turn the starter motor quickly enough, or supply adequate ignition current.
•
Refer to the following:
–
Starter clutch (page 10-6)
–
Combination switch (page 17-10)
–
Starter switch (page 18-3)
–
Neutral switch (page 17-12)
–
Clutch switch (page 18-5)
TROUBLESHOOTING
BATTERY IS DAMAGED OR WEAK
1. Fuse Inspection
Check for blown main fuse or sub fuse.
Is the fuse blown?
YES
– Replace the fuse.
NO
– GO TO STEP 2.
2. Battery Inspection
Make sure the battery is fully charged and in good condition.
Is the battery in good condition and fully charged?
YES
– GO TO STEP 3.
NO
– Change or replace the battery
3. Battery cable Inspection
Check the battery cables for loose or poorly connected terminal, and for an open circuit.
I
s the battery cable in good condition?
YES
– Faulty regulator/rectifier
NO
– • Loose or poorly connected battery cables.
• Open circuit in the battery cable.
4. Starter Motor Cable Inspection
Check the starter motor cable for loose or poorly connected terminal, and for an open circuit.
Is the starter motor cable in good condition?
YES
– GO TO STEP 5.
NO
– • Loose or poorly connected starter motor cable.
– • Open circuit in the starter motor cable.
5. Starter Relay Switch Operation Inspection
Check the operation of the starter relay switch (page 18-3)
Does the starter relay switch click?
YES – GO TO STEP 6.
NO – GO TO STEP 7.