Honda CB HORNET 160R 2015, Руководство по ремонту

Страница: 83 / 336

5-11
FUEL SYSTEM
JETS
Install the pilot screw with the spring, washer and new
O-ring, and return it to its original position as noted during
removal.
Perform the pilot screw adjustment if a new pilot screw is
installed (page 5-15).
Install the following:
– Needle jet
– Needle jet holder
– Main jet
– Slow jet
TORQUE:
Needle jet holder: 2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
Main jet: 2.1 N·m (0.2 kgf·m, 1.6 lbf·ft)
Slow jet: 1.5 N·m (0.1 kgf·m, 1.1 lbf·ft)
FLOAT
Check the tip of the float valve where it contacts the valve
seat for stepped wear or contaminated.
Replace the valve if the tip is worn or contaminated.
Check the operation of the float valve.
Inspect the float valve seat for scores, scratches clogging
and damage.
If the seat is damaged, replace the carburetor body.
Install the float valve to the float.
Install the float to the carburetor body.
Damage to the
pilot screw seat
will occur if
the pilot screw
is tightened
against the seat.
Handle the
jets with care,
they can easily
be scored or
scratched
PILOT SCREW
SPRING
WASHER
O-RING
O-RING
NEEDLE JET
HOLDER
VALVE SEAT
MAIN JET
SLOW JET
FLOAT VALVE
FLOAT
FLOAT VALVE