Hitachi HF-W2000, Инструкция по эксплуатации

Страница: 24 / 325

S-17
SAFETY INSTRUCTIONS (Continued)

Wear cotton gloves when replacing an HDD in order to prevent failure
caused by static electricity. If you do not, the data stored on the HDD may
get corrupted.

Make sure you check the correct procedure before you start the work.
If you do not follow the correct procedure, the data stored on the HDD may
be lost.
(Page 10-20) (Page 10-22)

Wear cotton gloves when replacing an HDD in order to prevent failure
caused by static electricity. If you do not, the data stored on the HDD may
get corrupted.

Make sure you check the correct procedure before you start the work.
If you do not follow the correct procedure, the data stored on the HDD may
be lost.

As a replacement HDD, do not use an HDD previously used in the A model
or the B model. If you do, this equipment may not operate properly or the
data on the HDDs may be lost because of configuration information
mismatches or other reasons.

Do not replace the two HDDs at the same time. If you do, the data gets
corrupted.

When you replace an HDD, make sure that you set the HDD into the offline
mode in the Hardware status window, and then remove that HDD and
mount the replacement HDD. If you mount or remove an HDD when the
hardware status cannot be checked, for example, immediately after the OS
starts, a failure may result.
(Page 10-23)

Do not use a replaceable component for longer than the recommended
replacement cycle. If you do, a deteriorating or worn-out component may
cause the equipment to fail.
(Page A-1)