Hioki ST5680, Инструкция по эксплуатации, Страница: 89 / 253

89
Continuous Voltage Rise Test
Setting the initial voltage
The initial voltage is set.
Press the
START
button and wait till the voltage reaches the initial voltage after 0.1 seconds. Raise
the test voltage to the end voltage at the set voltage raise speed to perform the test.
1 1
1
Press [BASIC] > [START VOLT] on the setting
screen.
2 2
2
Change the value using [▲] or [▼] and then
press [ENTER] .
0.25 kV , 0.5 kV , 1 kV , 2 kV , any voltage
Setting range: 0.010 kV * 1 to 7.999 kV
*1. Default setting
The upper limit is automatically set based on the end
voltage value in [END VOLT] .
[START VOLT] < [END VOLT]
Setting the end voltage
The end voltage is set.
When no dielectric breakdown occurred under the set test conditions, shut off the output of the test
voltage at the end voltage and finish the test.
1 1
1
Press [BASIC] > [END VOLT] on the setting
screen.
2 2
2
Change the value using [▲] or [▼] and then
press [ENTER] .
0.011 kV to 8.000 kV
Default setting: 5.000 kV
The lower-limit is automatically set based on the initial
voltage value in [START VOLT] .
( [START VOLT] < [END VOLT] )
Dielectric Breakdown V
oltage (BDV) Measurement Mode
HIOKI ST5680A961-00