Gyyr TLC2100-S16, Руководство по эксплуатации

Страница: 74 / 84

64 TLC2100-S16
1837-0700-4852542C
APPENDIX C: WARNING CODES
Digital Display
Codes An “Error” annunciator in the Digital Display will be displayed for the following
events:
• Error 1 - Cylinder Lock
• Error 2 - Mecha Lock-1
• Error 3 - Mecha Lock-2
• Error 4 - Reel Lock-1
• Error 5 - Reel Lock-2
The Warning Data may be displayed on the monitor by pressing STOP, DOWN and
H-POS when in a menu. A typical Warning Data line will be displayed as follows:
121 091297 133445 CYRD21
• The leftmost column displays the number of times the failure occurred. A “1”
means once, a “0” means twice. A line will record only one or two failures. In the
example above, the failure occurred once. The system will not go into the error
mode unless it gets the same error twice.
• Moving to the right, the next two columns display the number of event (from 0 to
99). The display will list the first warning and the last eight warnings. In the example
above, “21” is the 21st event.
• Moving to the right, the next six columns display the date on which the warning
occurred. In the example above, the date is September 12, 1997 (09/12/97).
• Moving to the right, the next six columns display the time in a 24-hour format
(hours-minutes-seconds). In the example above, the time is 1:34:45PM.
• Moving to the right, the next two columns display the Warning Data code. See the
“Warning Data Codes” table on the next page for an explanation of the codes. In the
example above, these column display “CY“. As listed in the Warning Data chart
below, “CY” stands for Cylinder Lock.
• Moving to the right, the next two columns display the Status Code. See the “Status
Codes” table on the next page for an explanation of the codes. In the example above,
these columns display “RD“. As listed in the Status chart below, “RD” stands for
REC (Record). In other words, the warning occurred while in RECORD mode.
• Moving to the right, the next column displays the Tape Speed Code. See the “Tape
Speed Codes” table on the next page for an explanation of the codes. In the example
above, this column displays “2“. As listed in the Tape Speed chart below, “2” stands
for A24 or A30.
• The rightmost column displays the Tape Position Code. See the “Tape Position
Codes” table on the next page for an explanation of the codes. In the example above,
this column displays “1“. As listed in the Tape Speed chart, “1” stands for 1/7. This
means the warning occurred in the last 1/7 of the tape.
To sum up:
1 21 091297 133445 CYRD21
Note: Perform a System Re-
set or power cycle unit by
disconnecting AC power to
clear the Error Message. One
of these two actions must be
performed to access the Main
Menu.
Time
(hours-minutes-
seconds)
Number
of times
Occurrence
number
Codes
(Warning Data,
Status, Speed,
Position)
Date
(month-day-year)