Gyyr TLC2100-S16, Руководство по эксплуатации

Страница: 28 / 84

18 TLC2100-S16
1837-0700-4852542C
Daylight Saving:
If the Daylight Saving feature is enabled, the VCR's time automati-
cally changes to accommodate the United States Standard Daylight Savings time
changes that can occur in April and October.
Note:
If the “Sync to ATM” setting, under the “Sync to ATM Time” menu is set to “Yes”,
then the VCR's “Daylight Saving” setting is ignored. In this case, since “Sync to ATM”
is set to “Yes”, it is assumed that the VCR is connected to an ATM, and then the VCR
will maintain its time to that of the ATM.
To set the clock in the Time: Date submenu:
In this example, the time and date will be set for 2:56 PM, March 6, 1997. It will be
assumed that the date format is mm/dd/yy (month/day/year). The date format will
be covered in the “Display Options: Date Format” section of this manual.
• If necessary, press PROG. to display the Main Menu
• The cursor will be next to the Time/Date submenu line.
• Press PROG. to display the Time Date submenu.
• The cursor arrow will be next to the Time parameter line.
• Press PROG. to begin editing. “12“, the hour position, will be highlighted.
• Press UP 14 times until “2” is displayed. “A” (AM) will change to “P” (PM).
• Press NEXT. “00” will be highlighted in the minutes position.
• Press UP or DOWN until “56” is displayed.
• Press NEXT to move to the next parameter to be edited, that is, “1” in the Date
parameter line. Note that the Seconds need not be programmed; as soon as NEXT is
pushed, the seconds will begin to count off automatically.
Note:
It is not necessary to exit the Time Parameter and then enter the Date
parameter. NEXT and PREV. will move to the next or previous parameter, even if
they're in another menu line.
• The “1” in the month position will be highlighted.
• Press UP twice. 3 (March) will be displayed.
• Press NEXT. “01“, the day position, will be highlighted.
• Press UP until “06” is displayed.
• Press NEXT. “96” will be highlighted.
• Press UP once. “97” will be displayed.
• Press PROG. to end editing for this line. The cursor arrow will be displayed again
next to the Time line.
• Note that the Day line will now display “Thu“. The Day parameter is automatically
entered after the Date parameter is entered.
• Press UP to move the cursor to the Exit line.
• Press PROG. to exit the submenu. The Main Menu will now be displayed.
• The cursor will be next to the Exit line of the Main Menu. Press PROG. to exit the Main
Menu.
• Your monitor will now display the Time and Date, often known as a Time/Date
stamp. See the “Display Options” section of this manual for more information about
the formats of the Time/Date stamp. If you have not yet programmed any of the
Display Options submenu parameters, the Time/Date stamp should appear as
follows:
3/06/97 THU A0
02:56:17P 02
Note: The letters “PL” may appear before “A0“. “PL” stands for power loss - it is
displayed when the power is interrupted. It often appears when the unit is first
switched on. “PL” may be turned off by pressing the Alarm Reset Button (Button #26).
Example of Setting
the Clock and
Navigating a Menu