GSK 218M, Руководство по подключению и программированию PLC

Страница: 167 / 227

GSK218M CNC System Connection and PLC Manual
164
2 ） Driver alarm signal ALM (input)
The receiving method of signal at the CNC side is as follows. The parameter 019bit0 set if
the driver fault is the low level “0” or the high level.
+5V +12V
Signal to CNC
R＝2K
XDALM
Fig. 2-2-3-2
The enabled level to the CNC can be set by customer if the low or the high is enabled. But the
driver must provide the signal as follows:
Fig. 2-2-3-3
3
）
CNC ready completion signal EN(contact output) CNC
CNC ready has been completed when the contact is closed. When CNC has detected the
alarm, the contact signal is OFF.
4
）
Referece point return with signal PC
The receiving method of signal at the CNC side is as follows.
0V
DALM
DALM