GSK 218M, Руководство по подключению и программированию PLC

Страница: 187 / 227

GSK218M CNC System Connection and PLC Manual
184
state
address
X4.7 X4.6
Pin XS45.06 XS45.18
X4.6=spindle speed arrival signal input
；
X4.7
＝
spindle zero speed check signal input.
Data parameter No.243
2 4 3
Spindle motor min. clamp speed .
Data parameter No.244
2 4 4
Spindle motor max. clamp speed.
Data parameter No.245
2 4 5
Time for check spindle speed arrival signal
Data parameter No.257
2 5 7
Spindle speed up limit during tapping cycle
Data parameter No.258
2 5 8
Spindle speed up limit
z Operation time sequence
Time sequence of spindle operation is as Fig. 3-3-1:
z Control logic
①
The spindle stops and M05 outputs when CNC is turned on;
② After M3/M4 is executed, it is enabled and M05 stops output.
4.10 Spindle automatic gear change control
z Signals
Y3.4
～
Y3.6
：
Spindle automatic gear shift output signal
X4.1 ～ X4.3 ： Spindle gear change completion signal
When CNC selects the spindle frequency conversion control (0
～
10V analog voltage output), it
Fig. 3-3-1 Spindle CW time sequence
Spindle CW/CCW
Spindle stop