GSK 218M, Руководство по подключению и программированию PLC

Страница: 131 / 227

GSK218M CNC System Connection and PLC Manual
128
[
Data Classfication
] Bit
INI Unit of input
:
0
：
mm
1
：
inch
Note: When this parameter is set, the power must be turned off before operation is continued.
11.4 Small hole peck drilling cycle
General
During peck drilling, the tool enters and retracts from hole based on an overload
torque check signal (skip signal) unitl the designed hole depth is reached. The
spindle speed and cutting feedrate are changed on each entry of the hole.
The cycle is realized by:
*X and Y axis positioning
*Positioning at point R along the Z axis
*Cutting along the Z axis (first time, depth of cut Q, incremental)
Signal small hole peck drilling signal
PECK2<F013#5>
[Classfication] Output signal
[Function] The signal reports if the small hole peck drilling is executed.
[
Output conditions
]
When this signal becomes “1”, the control unit operates as
follows:
1. Retracts the tool from Z point to R point /initial level after the tool
executes the hole positioning alogn the non drilling axis.
2. The signal is not 1 during the hole positioning.
Signal address:
PECK2
F013
＃
7
＃
6
＃
5
＃
4
＃
3
＃
2
＃
1
＃
0