GSK 218M, Руководство по подключению и программированию PLC

Страница: 188 / 227

GSK218M CNC System Connection and PLC Manual
185
can support 4-gear shpindle automatic gear change control and 4-gear change completion
check function.
z
Signal diagnosis
Parameter diagnosis(machine side output state)
state
address
Y3.6 Y3.5 Y3.4
Pin XS44.25 XS44.12 XS44.24
Y3.4=spindle gear 1 output
；
Y3.5=spindle gear 2 output
；
Y3.6=spindle gear 3 output.
Parameter diagnosis(machine side input state)
state
address
X4.3 X4.2 X4.1
Pin XS45.15 XS45.02 XS45.13
X4.1= spindle gear 1 in-position ； X4.2=spindle gear 2 in-position ； X4.3=spindle gear 3
in-position.
z Control parameter
State parameter No.001
0 0 1 Analog
spindle
Bit4 =1: It must be set to 1 when the spindle automatic gear change function is performed
during the spindle speed analog control mode.
=0: Spindle switch value control.
z Control parameter
State parameter
0 0 1 SPT
SPT
=1: Spindle control: I/O point.
=0: Spindle control: frequency conversion or other modes.
Data parameter No.246
2 4 6
Corresponding to max. speed of gear 1.
Data parameter No.247
2 4 7
Corresponding to max. speed of gear 2.
Data parameter No.248
2 4 8
Corresponding to max. speed of gear 3.
z Control logic
③
Upt to 1 of S1 ～ S3 is enabled;
④
S1
～
S3 stops output after S0 is executed;