GILES GEF-400, Руководство по эксплуатации и обслуживанию

Страница: 49 / 115

38
GEF & GEF-VH Series Fryers
Fryer Operation
5.1.2 General Operation - Fryer Controller
● POWER UP:
Place Power Switch in [ON] position. Controller will power up, then an alarm sounds. The message “POWER
FAILURE [PRESS START TO PREHEAT]” is shown on the Upper Display . This is normal , intended to prevent Fryer
from beginning to heat after power interruptions until attended by an operator. Pressing the [START] key
silences the alarm and places Fryer into PREHEAT mode. If the Selector Switch is in the [COOK] position, and
temperature setpoint is higher than the current actual oil temperature, heating elements will turn ON and
cooking oil will begin to heat
● PREHEAT:
During the PREHEAT phase, the real-time actual oil temperature is displayed on the Lower 7-Segment Display .
When oil reaches the programmed setpoint, an alarm tone sounds, the Upper OLED Display will display message
“ALARM, STIR OIL” . Vigorously stir the cooking oil, and press [ALARM] key. Typically, oil temperature will drop
when stirred. Controller has a 10 second delay and if oil temperature drops below setpoint, PREHEAT state
continues until oil returns to setpoint. This process helps ensure that temperature is more uniform throughout
the total volume of oil, leading to better cooking performance. Upon reaching setpoint, the alarm sounds again
and the Upper Display reads “ALARM - SETPOINT REACHED” . Pressing the [ALARM] key, places the Fryer in
READY state.
● READY STATE:
Fryer is ready for cooking. The current cooking temperature setpoint will be shown on the Lower Display and
the last used cooking parameters (preset or manual inputs) are shown on the Upper Display .
While in PREHEAT or READY state, User can select (or change) a Menu Item Preset, see Section 5.1.4.2, Selecting a
Menu Prese t , which automatically changes cook temperature and cooking time to the Menu setting -OR- User can
manually set a cooking time and/or cook temperature, see Section 5.1.3, Setting a Manual Temperature & Cook
Time .
NOTE: If the PASSCODE ENABLE parameter is set to [ON], User cannot manually set Time or Temperature
without entering a password. This lockout feature helps ensure consistent cooking procedures across multiple
user locations.
● START:
Information for a selected Menu Preset, or a manually set time and
temperature, is shown on the Upper OLED Display . To start the
cooking cycle, press the [START] key.
+
The following is general operational information only. Detailed procedures and instructions are covered in
subsequent sections. During operation, certain instructions and prompts will be shown on the Upper OLED Display
to step Users through processes. Some Controller keys and indicator lights will illuminate to further guide the User.