GILES GEF-400, Руководство по эксплуатации и обслуживанию

Страница: 43 / 115

GEF & GEF-VH Series Fryers
Pre-Operation Checkout
32
4.2 Power Test
The following test confirms that the unit is
properly receiving power.
1. Set up unit as described in
Section 4.1 .
2. Be sure the main circuit breaker powering
the unit is ON .
3. Place the Power Switch
①
in the ON
position. The green Power Light
②
will
turn on, the Controller will boot-up and the
message
[HOLD] is shown on the lower display. An alarm sounds and a message is shown on the upper display.
If all of this occurs, return Power Switch to [OFF] and see Section 4.3 ; if not, refer to troubleshooting
procedures in Section 8.1 .
4.3 Heating Element Test
1. Set up unit as described in Section 4.1 .
2. Be sure Power Switch is in the [OFF] position.
3. Liberally dampen heating elements
①
with a wet sponge, or
towel, such that visible moisture remains.
4. Place the Power Switch ② in the [ON] position.
5. Wait until Controller powers-up, press [ALARM] key to silence
alarm, then press the [START] key to enter PREHEAT . A Menu
Item Preset appears on the OLED Upper Display
③
and
Controller will call for HEAT .
6. Place the Selector Switch
④
in the [COOK] position. Leave it
there NO MORE THAN 10 -15 SECONDS and then return it and
the Power Switch to the [OFF] position
7. The moisture on the elements should quickly dry and heat
should be felt rising from the pot.
If the heating elements do not dry and/or
no heat can be felt, refer to the
troubleshooting procedures in Section 8.1 ,
otherwise see to Section 4,4 .
1
1
2
3
4
2
The following test confirms that the Heating Elements are being energized.
DO NOT touch the heating elements. They quickly become very hot, and skin contact may
result in a severe burn injury.
[ALARM]
[START]