8.2
The test report
General
Information about an installation including the results from the component test are
stored and can be compiled into a printed report.
If the option Print report automatically was chosen initially in the installation wizard
(
Open the installation wizard, on page 84
), the results from the component test run will
be available in the form of a printed report produced immediately after the test has fin-
ished.
If the option Print report automatically was not chosen, a printed report can be created
at a later time: In the UNICORN Evaluation module, click Report on the File menu and
then select AKTA ready_FlowKit.
What does the report contain?
A flow kit installation report in AKTA ready_FlowKit format, including component test
results, contains the following parts (in the order they occur in the printed document):
Header
A header containing basic information is shown at the top of each report page. The in-
formation includes the UNICORN version number, the name of the person who ran the
test, and the time and date for the test. Also the path for the result file is shown in the
header.
Questions
The Questions section contains identification information. This is the same information
as that entered in the Questions panel in UNICORN, i.e. product name and number,
barcodes for flow kit parts and pH electrode, protocol for test solution preparation, and
the mode for entering codes.
Method notes
The Method notes section contains the name of the system, and a list with the different
steps that were taken when installing the flow kit. The steps are the same, and in the
same order, as the steps in the installation wizard.
Start notes
Start notes include any notes entered before starting the test run in the start protocol.
Run notes
Run notes include any notes/comments entered during the test run.
ÄKTA ready Operating Instructions 28960345 AD
113
8 Component test
8.2 The test report
