GCC Technologies RX II Series, Руководство пользователя

Страница: 72 / 229

RX II Series User Manual
The Control Panel 3-6
Die/Kiss Cut:
Length: 9.0 / 0.2 mm
Die/Kiss Cut:
Force: 450 g 45 g
3.4 Menu Items
Below describes the functions of menu items
Menu or Key Function Setting Default
--- Media sizing ---
Roll To measure media width.
Maximum Media
Length 150M
Edge To measure media width and pull the media back till the front
paper sensor open.
Maximum Media
Length 150M
Single To measure media width and length.
Maximum Media
Length 10M
--- POWER ---
To indicate the power status.
[ Arrow Keys ]
1. To move the tool carriage position on X or Y axis.
2. To select functions or change values of settings.
[ ENTER ]
1. The displayed parameters will be saved automatically.
2. To set a new origin at the present tool carriage position.
In “offline” mode, moving the tool carriage to desired
position by [Arrow Keys], then press [ENTER] key to set a
new origin. While moving with the parameters of XY-axes
displayed, press [MISC] key will enable fine-tune
movement; press [MISC] key again to disable the function.
[ PAUSE/RESUME ]
DHCP
Select: OK:ENTER
Enabled, Disabled
IP Address
Select: OK:ENTER
IP Address set, Submask set,
Gateway set
MAC Address
00:CF:52:72:03:01
Select Unit
Select: OK:ENTER
Metric (cm/g), Unit (inch/ g),
Unit (cm/ oz), English (inch/ oz)
[ MISC]
Scale Length
Select: OK:ENTER
Scale Width
Select: OK:ENTER
Image Scale Length
Select: OK:ENTER
Image Scale Width
Select: OK:ENTER
Die/Kiss Cut: ON
Select: OK:ENTER
Section Cut
Select: OK:ENTER