GCC Technologies RX II Series, Руководство пользователя

Страница: 105 / 229

RX II series User Manual
Automatic-Aligning System
5-6
5.3 Printer Test
Before performing AAS contour cutting, it’s recommended to print out a test file that you
can find in the enclosed Installation CD to make sure the AAS II cutting accuracy of RX II
series.
There are two testing files for AASII:
1. AAS II_X_Y_Offset_Caberation_A4 .eps (A4 size)
2. AAS II_X_Y_Offset_Caberation_600_600 .eps (Default setting, it is recommended
for testing)

Print out the testing graphic. ( Please use high precision printer)

Load the graphic to RX II series and sent the file to test the cutting job

If there are any adjustments to be made, you can change the offset value by
following the steps:
■ Measure the offset values from the printed line and the actual cutting line.
■ Enter the AAS Offset under MISC function for the values you just measured,
then press Enter
■ Test the cutting again
■ AAS II offset X and Y value is defined as following:
Horizontal line is defined as X and vertical is defined as Y (when facing the
cutting plotter)
■ When the actual cutting line and the printed line need to be changed towards
the direction of origin mark, then simply add the negative value of the offset. If
the direction is from the opposite of the origin mark, then enter positive values
for the offset (see the following figures). This method applies to both X and Y
axes.