GCC Technologies RX II Series, Руководство пользователя

Страница: 69 / 229

RX II Series User Manual
The Control Panel 3-3
3.2 Menu in On-line Mode
Power on When Setting Paper
When Media Is Detected
Main Menu
3.3
Set Tangential Mode
Select: OK:ENTER
Pouncing: 0 mm
Select:
OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
1S:72 F:80 O:0.275 M
Select: OK:ENTER
Clear Data Memory
N:ONLINE OK:ENTER
Offset: 0.275 mm
OK:ENTER
C Force: 80 gf
OK:ENTER
P Force: 80 gf
OK:ENTER
Firmware: X.X Copyright: GCC
Place Media And Then
Lower Down The Lever
Roll Edge Single
Key Key Key
Load: Pull Lever Up
To Setup: Valid Keys
To Load: Place Media
To Setup: Valid Keys
use to select
Initializing RX
Please Wait…
Press Function Key
IF NEEDED
** Please Don’t **
*** TOUCH ANY KEY ***
Now Sizing Media
Sizing Media Length
Lever Up to Abort
Sizing Media Width
Lever Up to Abort
Pause Setup Resume
Sending data
[
PAUSE
]
[ FORCE]
use to select; [ENTER] to enable the setting
[ SPEED ]
[ OFFSET ]
[ DATA CLEAR
]
[TOOL SELECT ]
S 72 F 80 O 0.275
L:150000
W:327 T1M
Speed: 72 cm/s
Select: OK: ENTER
UP Speed: 72 cm/s
Select: OK: ENTER
Up Accel.: Medium
Select: OK: ENTER
Quality: Normal
Select: OK: ENTER
AAS Speed: Medium
Select: OK: ENTER