635-SERIES HARDWARE M ANUAL
Chapter-Page
2-25
4.3 Install the DIO Board in the Controller
If you are not installing a DIO board, skip this section.
The DIO board is a 600-model board (there is not a 635 version of this board).
600-DIO - BOARD FEATURES
Board Reset Switch (SW1):
for resetting the board to initialize the Jumpers and Dipswitch settings, or reset operation.
Configuration Jack (J9):
must be installed when configuring the Board ID – can configure after installing the board.
Power Input (J10)
for connection to controller power harness.
Power LED (D5)
indicates board is connected to the power harness and the power is on (solid/on).
I2C Data Input (J12)
for ribbon cable connection to the CPU Board I2C Data Buss.
Input Connectors (J1, J2, J3, J4)
for connecting inputs 1 thru 8 (8 Input points provided).
Output Connectors (J5, J6, J7, J8)):
for connecting outputs 1 thru 4 (4 Output Relays are provided; Form-C 1.5 A max.).
LEDs for Output Relays (D1, D2, D3, D4)
indicate when the relay is engaged (solid/on) or disengaged (off).
Figure 18 – 600 DIO Board Features:
Diagram shows board component-side up. The board installs component-side down. Power input should be on the same
side as the power harness when the board is installed in the controller.
DRAWING IS APPROXIMATE - NOT TO SCALE
