Furuno FV-110GX, Руководство оператора

Страница: 155 / 188

C-1
Appendix C
Command line interface
C
C.1 Introduction
After you have done the initial configuration and connected the FV-110GX system to
your network, you can use Telnet to configure the FV-110GX system. You can also setup
VSAT modem parameters.
After successful login you can read and change settings. Use the command
config
activate
to activate the new settings in the ACU. You will need to refresh the browser
window before the changed settings become visible.
C.1.1 Telnet connection
You can access the command line interface via Telnet.
Access to the FV-110GX system is protected by a user name and password. This is the
same user name and password that is used in the web interface under
ADMINISTRATION .
The interface is on the standard Telnet port 23 or SSH port 22. Use any LAN port and
corresponding IP address of the ACU (except LAN 2 on GX/Ka ACU). To start telnet
session do as follows:
1. Open a Telnet client of your choice.
2. At the prompt, enter the IP address of the ACU, login admin and password.
Figure C-1: How to use the command line interface (example for telnet)
Note
Every change is performed on the active satellite profile or the active VSAT
modem profile. Parameter identifiers are case sensitive.
Write new settings to
FV-110GX
Read or change settings Connect to FV-110GX
using IP address
Figure C-2: Command line interface, login