Furuno FV-110GX, Руководство оператора

Страница: 150 / 188

List of ACU events
B-8
B.3 List of ACU events
Error
code
(ID)
ACU
PCB
Severity Description Explanation
08060-0 ADM WARNING Antenna modem ACU/Antenna communication error detected
(framing and parity). If the situation is persistent,
check if cable specifications comply (length and
attenuation).
08063-0 ADM ERROR Antenna connection The ACU has lost connection with the antenna.
08064-0 ADM ERROR ADM PLL lock The intermediate frequency PLL is not in lock.
Check the 10 MHz reference signal.
08065-0 ADM WARNING GNSS data Missing GNSS data (fix).
08066-0 ADM WARNING Heading data Missing heading information. Check cable and
heading provider device.
08067-0 ADM ERROR PCB temperature ADM temperature too high. Make sure there is
compliance with the environmental
specifications.
08068-0 ADM ERROR PSM power The PSM fails to provide the requested supply
voltage.
08069-0 ADM WARNING Blocking Zone The antenna has entered a blocking zone.
0806A-0 ADM WARNING VMU connection The ACU has lost connection with the sat
modem.
0806C-0 ADM ERROR VMU frequency
setup There is a mismatch in the frequency setup.
Probably the sat modem is not configured
correctly to match the requirements of the ACU
and antenna. A common mismatch is the absence
of Rx or Tx LO parameter in the VSAT modem.
0806D-0 ADM ERROR Antenna power The antenna supply voltage is outside the
allowed limits. This may happen if the PSM fails
to provide the requested supply voltage.
0806E-0 ADM ERROR VMU reference
signal There is no VMU Rx or Tx reference signal.
Whether this is Rx or Tx reference depends on
the user's selection on the modem profile page in
the web interface. Make sure VMU Rx/Tx cable
is connected and that the VMU is configured to
output the RX/TX reference signal.
Table B-2: ACU event messages