Fuji Xerox apeosport-IV 6080, Руководство администратора

Страница: 450 / 705

15 Problem Solving
450
P
roblem S
o
lv
ing
15
003-700 [Cause] Too many documents are set in the document feeder after clearing the
paper jam.
[Remedy] Check the output, and then replace the documents that have not been
copied yet.
003-701 [Cause] A digital code is embedded in the document to restrict duplication.
[Remedy] Use a document in which no digital code is embedded.
003-702
[Cause] You tried to copy sides 1 and 2 of a document simultaneously specifying
different Reduce/Enlarge ratio for each side.
[Remedy] Specify the same Reduce/Enlarge ratio for both sides.
003-703
[Cause] The Calibration Chart is not detected correctly.
[Remedy] Place the Calibration Chart properly.
003-704
[Cause] An error is found in the calibration pattern read, and the machine may be
out of order.
[Remedy] Execute the calibration again. If the error is not still resolved, contact our
Customer Support Center.
003-705
[Cause] Copying is started before the machine exits the Energy Saver mode and
detects the change for the tray size, when the paper size set in the tray
that has been changed during the Energy Saver mode.
[Remedy] Cancel copying, and perform the operation for copying again.
003-750
[Cause] Unable to store any documents using the 2 Sided Book Copying feature.
[Remedy] Check the 2 Sided Book Copying settings.
Refer to "3 Copy" > "Layout Adjustment" in the User Guide.
003-751
[Cause] Unable to process the document because the specified scan area is too
small.
[Remedy] Increase the resolution or scan area.
003-752 [Cause] A mix sized document was to be scanned at 600 dpi in Color/2 sided.
[Remedy] Set [Resolution] to [400dpi] or lower, and try scanning again.
003-753 [Cause] A mix sized document was to be scanned at high resolution, 2 sided.
[Remedy] Set [Resolution] to [200dpi], and scan the document again.
003-754
003-755
[Cause] An error occurred in the document feeder.
[Remedy] Execute the job again.
003-756
[Cause] The faxed document is completely blank.
[Remedy] Check whether the document is blank or whether the side of the
document to be faxed is loaded correctly.
003-757 [Cause] A mix sized document was to be scanned at high resolution, 2 sided.
[Remedy] Set [Resolution] to [300dpi] or lower, and scan the document again.
003-760
[Cause] An incompatible combination of feature is specified for document scan
conditions.
[Remedy] Confirm the selected options.
003-761
[Cause] The paper size of the tray selected for auto tray differs from the paper
size of the tray selected for Auto Paper selection.
[Remedy] Change the paper size for the tray, or change the [Paper Type Priority]
settings.
003-764
[Cause] Although [Form Overlay] is specified, only one document page is
loaded.
[Remedy] Set a document to use as the form document and a document to
overlay.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.