FSK RHINO 816, Руководство по установке, Страница: 10 / 51

10 FSK-RAP816-V2015.04
Remote Keypads
PCB Layouts
LED Remote Keypad
Graphic LCD Remote Keypad
1. Network Connections
The remote keypad is connected to the network terminals located
at the bottom left hand side of the PCB.
2. Address Selection (Led keypad only)
Each remote keypad must be assigned a different address using the
Address selector. Move the jumper to the required position 1, 2, 3
or 4. To assign a keypad number to a graphic LCD remote keypad,
please refer to the graphic LCD keypad manual.
3. Piezo Sounder
The piezo sounder generates low level alarm, key press, and
warning tones. Each type of tone can be enabled or disabled for
each remote keypad, please refer to page 28 for further details.
Wiring Detection Devices
The Rhino 816 provides 8 zones for connecting detection devices
such as movement sensors and magnetic door contacts. Each zone
is fully programmable to allow for maximum flexibility (see page 19
for Zone Programming details). The program options for a zone will
also determine how the zone may be wired. The following wiring
options are available:
Normally Closed
This wiring configuration should be used when connecting detection
devices that only have a normally closed alarm output. Connect the
detector as shown below and ensure that the zone is programmed
for “Normally Closed” operation, see page 20.
Normally Open
This wiring configuration should be used when connecting detection
devices that only have a normally open alarm output. Connect the
detector as shown below and ensure that the zone is programmed
for “Normally Open” operation, see page 20.