Flintec FT-111 AN, Техническое руководство

Страница: 99 / 146

FT-111(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 98 of 146
Modbus Command Table;
Address R/W Word Command Definition
40001 R 2 Actual weight (Net if the indication is in Net, Peak value or Hold value)
40003 R/W 2 Tare weight
40005 R 2 Gross weight
40007 R 2 Status
Bit Definition
B0 0
– Dynamic is inactive
1
– Dyn weight is calculating
B1 0
– Weight is actual w.
1
– Weight is dynamic result
B2 0
– Weight is Stable
1
– Weight is unstable
B3 0
– Gross mode
1
– Net mode
B4 Not used
B5 0
– Not power on zeroed
1
– Zeroed with pwr on zero
B6 0
– First Unit (power on)
1
– Second Unit
B7-B10 Not used
B11 0
– Key lock is passive
1
– Key lock is active
B12 0
– Out of center of zero
1
– Weight is in center of zero
B13 0
– High res. is passive
1
– High res. is active
B14 0
– Basic Peak is passive
1
– Basic Peak is active
B15 0
– Hold is passive
1
– Hold is active
B16-B26 Not used
B27 0
– None
1
– Decimal point is X.XXXX
B28 0
– None
1
– Decimal point is X.XXX
B29 0
– None
1
– Decimal point is X.XX
B30 0
– None
1
– Decimal point is X.X
B31 0
– None
1
– No decimal point
40009 R 2
Error
Status
Bit Definition
B0 0
– No Error
1
– Low voltage det.
B1 0
– No Error
1
– In programming mode
B2 0
– No Error
1
– System error
B3 0
– No Error
1
– ADC under range
B4 0
– No Error
1
– ADC over range
B5 0
– No Error
1
– ADC out of range
B6 0
– No Error
1
– Tilt Switch is active
B7
– B31
Not used
40011 R 2
Heartbeat for connection checking, this value is increased every
100 milliseconds.
40013 R 2 Last print value
40015 R/W 2 CN (Label number) Refer to parameter [254] on page 56
40017-24 R 8
40025 R/W 2 Commands
Dec Definition
0 None
1 Zero
2 Tare
3 Clear
4 Print
5 Reprint the last label
6 High resolution enable
7 High resolution disable
8 Unit change (from first to second unit)
9 Unit change (from second to first unit)