The remote control menu <Programming>
Doc. no. BA012498_03
74 / 112
GB
To achieve the most precise lighting with constant brightness, you
need to connect lights with an integrated light sensor. The light
sensor can be further calibrated. For more information on cali-
brating the light sensor, see Section “Calibration” page 52.
In the default factory setting, the DALI detector measures the brightness. If
the detector receives too much ambient light due to its installation position,
this may impair the constant lighting control. In this case, you can deacti-
vate light measurement through the detector.
Deactivating light measurement using a DALI detector:
Prerequisites:
• Chose a position as close as possible to being directly underneath the
presence detector.
• Aim the remote control directly at the detector so that only this device
receives the remote control signal.
1. Select the <Programming> menu item and confirm the selection with
the
button.
2. Enable programming mode by pressing the
button.
3. Select the
button to choose the menu item <Light value off> and
confirm the selection with the
button.
The red LED flashes three times in the sensor head.
4. End programming mode by pressing the
button.
Light measurement is deactivated.
Re-activate light measurement using the <Light value on> menu item.
8.15 Detector factory reset
The
Detector Fact. reset
function enables you to reset the following settings
to the factory settings:
• Send light value
• Sensitivity of the presence detector
• Detector LEDs
The detector factory reset does not change any other settings, such as for
the switch-off delay time.
Performing a detector factory reset:
1. Select the <Programming> menu item and confirm the selection with
the
button.
2. Enable programming mode by pressing the
button.
Lights with light
sensor
