The <Functions> remote control menu
Doc. no. BA012498_03
51 / 112
GB
7.7 Test start/stop
The
Test start
function tests the detection range of the detector. During the
test phase, the lighting is set to maximum brightness.
Activating the test function:
1. Select the <Functions> menu item and confirm the selection with the
button.
2. Select the
button to choose the menu item <Test start> and con-
firm the selection with the
button.
The entire lighting is switched on.
The blue LED flashes in the sensor head when motion is detected.
Ending the test function:
1. Select the <Functions> menu item and confirm the selection with the
button.
2. Select the
button to choose the menu item <Test stop> and con-
firm the selection with the
button.
The test lighting switches off.
7.8 KNX Prog. On/Off
These remote control commands are for Light Control Boxes with a KNX
module. The command <KNX Prog. On> enables you to assign a physical
address to the KNX module.
Activating the KNX program function:
1. Select the <Functions> menu item and confirm the selection with the
button.
2. Use the
button to select the menu item <KNX Prog. On> and
confirm the selection with the
button.
The KNX module is in programming mode.
Ending the KNX program function:
1. Select the <Functions> menu item and confirm the selection with the
button.
2. Use the
button to select the menu item <KNX Prog. Off> and
confirm the selection with the
button.
The KNX module is no longer in programming mode.
